高新技能企业 · 轿车深度保护品专业供货商

全国招商热线:13318861726

当时方位:主页 > 产品中心 > 产品类别 > 轿车尾气管理轿车尾气管理
优道三元催化高效清洗剂 轿车尾气管理

1. 有用铲除三元催化器外表的积碳及残留物。

2. 康复三元催化器的净化功用,下降尾气排放。

3. 提高燃油焚烧功率,提高冷车发起功用,下降油耗,康复发起机动力。

4. 延伸三元催化器的运用寿命,削减保护归纳本钱。

  • 优道三元催化高效清洗剂 轿车尾气管理
  • 优道三元催化高效清洗剂 轿车尾气管理

优道三元催化高效清洗剂

品牌:UD优道

体系:进排气体系

产品编号:UD-01.265/325ml

企业规范:Q/YKJH 8

产品仅供4S店运用


产品特色:

1. 有用铲除三元催化器外表的积碳及残留物。

2. 康复三元催化器的净化功用,下降尾气排放。

3. 提高燃油焚烧功率,提高冷车发起功用,下降油耗,康复发起机动力。

4. 延伸三元催化器的运用寿命,削减保护归纳本钱。


运用方法:

1、发起发起机至正常工作温度,

2、用专用油门固定器将引擎转速固定在2500转

3、寻觅、拆开节气门后的真空管(有真空吸力),接近节气门第一个管口最佳,

4、把产品瓶口翻开衔接在专用清洗设备上(或倒入设备铁罐中),并把设备出液通明软管与轿车的真空管对接,

5、翻开设备开关,将流量调整开关调到产品成滴入装状进入真空管为正确,清洗时刻为25-30分钟最佳,

6、整瓶产品用完,除碳时刻完结,拔出衔接轿车真空管接头并康复原状,

7、将油门固定器拆下,以每500转/10秒轻缓加油,逐步加至3000转,以稍快速度重复上述动作。

8、待进排气声顺利时再排碳15分钟,除碳中及排碳时绝不能够重踩油门,排碳后有必要进行路试。


Product features:

1. Effectively remove the carbon deposition and residue on the surface of the ternary catalytic converter.

2. Restore the purification function of the three-way catalytic converter and reduce the exhaust emission.

3. Improve fuel combustion efficiency, improve start-up performance of cold vehicle, reduce fuel consumption and restore engine power.

4. Extend the service life of three-element catalytic converters and reduce the comprehensive maintenance cost.


Usage:

1. Start the engine to the normal operating temperature,

2. Fixed the engine speed at 2500 revolutions with special accelerator fixator

3. Look for and open the vacuum tube behind the throttle (with vacuum suction). It is best to be close to the first pipe opening of the throttle.

4. Open the product bottle mouth and connect it to the special cleaning equipment (or put it into the equipment tin), and connect the device's liquid outlet transparent hose to the vacuum tube of the car.

5. Turn on the device switch, and adjust the flow rate adjustment switch to the product to drip into the vacuum tube. The cleaning time is 25-30 minutes.

6. When the whole bottle of product is used up, the decarbonization time is completed, and the vacuum tube connector of the car is pulled out and restored to its original state.

7. Remove the accelerator fixator and gently refuel every 500rpm / 10s, gradually add to 3000 RPM and repeat the above action at a slightly faster speed.

8. When the inlet and exhaust sound is smooth, the carbon shall be discharged for another 15 minutes. In addition, the gas pedal shall not be pressed again when the carbon is removed and the road test shall be conducted after the carbon is discharged.


回来顶部